http://swrc.ontoware.org/ontology#Article
砥粒切削方向が研削面粗さに及ぼす影響について —非軸対称非球面研削に関する研究—
ja
parallel grinding
cross grinding
grain cutting direction
statistical grinding theory
吉原 信人
閻 紀旺
厨川 常元
精密工学会誌
76
7
781-785
2010-01-01
0912-0289
Surfaces of optical parts are required to be smooth. Therefore, polishing is carried out. The period of polishing process depends on the roughness of ground surface. To shorten the period of polishing process, the roughness of ground surface must be smooth. In this paper, to clarify the optimum grinding condition, maximum height roughness of traverse ground surface is analyzed theoretically utilizing the statistical grinding theory. From the view point of relationship between the grain cutting direction and workpiece feed direction, the grinding condition is classified into parallel grinding and cross grinding. And it is found that the parallel grinding has an advantage in rough grinding, and the cross grinding is suited to finish grinding.
公益社団法人 精密工学会
Copyright © 2010 公益社団法人 精密工学会
10.2493/jjspe.76.781